New member

[lennard]

Hellow all,
new member, living in Gippsland area of Victoria, Australia.
My interests are model boat building and steam engines. Thought i might combine the two and build a square rigged paddle steamer, and am just researching the project.
happy to hear from anyone with ideas or plans.
thanks, lennard.

[Eddy Matthews]

Welcome Lennard,

An old square rigged paddler that is steam powered would be a challenge to build - Not impossible, but you'd have to selct a prototype carefully, and keep top weight etc to a minimum if you were to end up with something reasonably stable....

Regards
Eddy

[EMBC]

Hello there!

Here`s my idea of a square rigged paddle steamer.....   http://www.modelboats.co.uk/albums/member_album.asp?a=422......Great Eastern!

Bob

[Walter Snowdon]

I think the Great Eastern is a bit extreme unless it is built really large. I would find something with just two masts preferably with the minimum of square sails. What about theGREAT WESTERN? The airfix plastic kit would be a good guide. OR a model of the first sidewheel paddler built in Australia?. It was a good looking ship with a broad beam and a full size replica still exists somewhere in Australia. Sorry ,its name escapes me, But I think the original went to china after serving on the Australian coast. regards, walter.

[bri]

Hello all   new member my name is brian  I live in minnesota usa Some of my interests are steam engines and model airplanes and boats.    bri

[generalfitter]

hi my names jake I'm new to steam engines but would love to try build one,Funny thing is all the plans Ive come across are  in imperial sizes,As in from New Zealand I'm really trying to find a metric plan of one 
thanks

[R.G.Y.]

genralfitter, Try to get Stan Bray's book "Simple Model Steam Engines" plans are shown in imp; & metric. I have heard some measurements are printed wrong. But from the information I designed my own engine, and I am sure anyone else could do the same. Photo attached. R.G.Y.

[peter42]

 
Hi !!
I am Peter. I have a small engineering workshop at home. I am a complete newbie, but I am determined to become a proficient machinist. I certainly require lots of help and encouragement from you PROS.