Paddleducks

General => Introduce Yourself => Topic started by: Southern Belle on November 25, 2011, 03:01:43 AM

Title: Hello everyone
Post by: Southern Belle on November 25, 2011, 03:01:43 AM

Hey all ...My name is rick and I am new to paddle wheeler modeling.. I am curently building the 1973 Krick "Southern Belle" what a blast!  However I am into authenticity and would like to provide an actual stam plant for power..All the engines I have seen are verticle..any Ideas?

Title: Re: Hello everyone
Post by: Dave R. on November 30, 2011, 03:52:54 PM

Hey Rick, welcome to the group.
I was just recently researching the Krick "Southern Bell". I never
did figure out it's scale; I read it incorrectly gives 1/72 as scale
on the side of the box.
What's the skinny?
Dave

Title: Re: Hello everyone
Post by: the bombus on November 30, 2011, 05:37:39 PM

hi dave
i checked out a southern belle visiting a friend a while back
i think it's more in the 1/48 or 1/32 range
perhaps southern belle could post a picture of a door with a measuretape allongside with it ?
that way we could have a good idea of the scale
1/72 is a HUGE mistake i agree
greetings from bombus

Title: Re: Hello everyone
Post by: steamboatmodel on December 01, 2011, 02:36:22 AM

Quote from: Southern Belle on November 25, 2011, 03:01:43 AM

Hey all ...My name is rick and I am new to paddle wheeler modeling.. I am curently building the 1973 Krick "Southern Belle" what a blast!  However I am into authenticity and would like to provide an actual stam plant for power..All the engines I have seen are verticle..any Ideas?

Hi Rick,
I think what you need is a long stroke horizontal engine similar to a Mill engine. I am not sure what the space is like in the Southern Belle, but most of the current commercial engines are probably too large and heavy for your needs. You may have to fabricate your own.
Regards,
Gerald.

Title: Re: Hello everyone
Post by: mjt60a on December 18, 2011, 12:57:27 AM

the adverts for the Krick Southern Belle said it was 37.25" long (but doesn't specify if that was to the back of the sternwheel or just the hull) Having seen a completed one, I'd say it was 1/32 judging by the height of the doors but I may be wrong as didn't have a 1/32 scale figure to place on the deck....  if I remember right there used to be a styrene (?) kit available that was probably 1/72....
by the way, about 6 years ago I posted a pic of this ad and some others from an old copy of 'radio control boat modeller' I think it was,... it's still there! - http://www.paddleducks.co.uk/smf/index.php?topic=162.msg563#msg563