Paddleducks

General => Chat & Off Topic Stuff => Topic started by: R.G.Y. on December 03, 2010, 02:29:08 AM

Title: small plans
Post by: R.G.Y. on December 03, 2010, 02:29:08 AM

Didn't know where to post this? I see in the down load section, plans large enough to enlarge without losing resolution. What I have done when a plan is small, is to enlarge until the lines are 1/8th wide. Then use carbon paper to transfer, drawing down the center of the lines. Using this method I have built a 4ft model from a drawing 3inches long. the proof. The second enlargement can be seen behind the model. Geoff