Paddleducks
Other Marine Models => Live steam => Topic started by: SKYPUP on October 02, 2006, 05:15:02 AM
-
Folks
Go here for simple and effective small tube benders http://www.hobbylinc.com/htm/k+s/k+s321.htm (http://www.hobbylinc.com/htm/k+s/k+s321.htm)
BOB
SAN ANTONIO, TX
WHAT A WONDERFUL TOWN
From: "Bill Hudson" <livesteam@paddleducks.co.uk>
Reply-To: livesteam@paddleducks.co.uk
To: livesteam@paddleducks.co.uk
Subject: RE: Small Diameter Tube & Tube Bends
Date: Sun, 01 Oct 2006 16:47:43 +0100
Dave_Sohlstrom wrote: Bill I saw the bender that your group was selling looked very nice. Would of loved to have one but talked the wife into a 4" rotary table from Little Machine shop.
Question: Are there plan sets available for your groups bender for those that would like to build one from scratch.
Dave
The benders went over very well. I finally got a set fro my contribution of labor. Have not had any chance to see how well they work.
Little Machine shop got some money from me too. (http://www.paddleducks.co.uk/forum/images/smiles/shhhh.gif) my wife. I picked up a quick vise for my mill.
At this time I don't think the club is giving out the plans.