Forum > Accessories, Lighting, Sounds etc

canvas lifeboat covers

(1/3) > >>

djcf:
Hi all,

Does anyone have any suggestions about a suitable material for making canvas lifeboat covers? I will also use this for canvas dodgers around bridge railings.
In the past I have used the foil covering that came on top of Flora margarine, however they have changed this now!
I have some Egyptian cotton cloth that I may try but it seems a bit chunky and stiff. It would be good to get something that I can "mould" around the rails, as if the wind is blowing on it!
The scale of the model it's for is 1/4"  -  1 foot.
cheers
Clark

Eddy Matthews:
I've always used paper kitchen roll soaked in PVA.... You can mould it to the exact shape you want, including the odd crease here and there to make it look more realistic, and once the PVA dries it's fairly stiff and easily painted to your desired colour.

Regards
Eddy

djcf:
Hi Eddy
The pva sounds a good idea, did you thin it down with water? If I remember correctly from my model rail scenery days, a touch of washing up liquid should make the pva soak in better.
Clark

Eddy Matthews:
I've never watered the PVA down Clark, the kitchen roll gets too soggy with water added and simply falls apart... Just neat PVA works for me.

Regards
Eddy

mjt60a:

What I did was;
Covered the railings with cooking foil and pressed it gently against them so the rails and stanchions show through a bit... cut a piece from an old ( not too old) shirt and ironed it smooth then trimmed it to a little bigger than is needed.
hold it in place over the foil using clothes pegs to start with and apply sanding sealer until the cloth is soaked through and lays in the depressions in the foil. allow to dry (once it's had sealer applied to a fairly large area, clothes pegs can be removed and it stays in position)
when it's dry to the touch remove the foil from the railings and attempt to remove the cloth, allow the 'inside' to complete drying (this causes it to roll up but it won't matter!) the cloth can then be trimmed to the required size without fraying and should 'fit' onto the railings. I left some 'tabs' on the top edge which can be bent over and glued to the bottom of the rail capping later.
I then painted the cloth matt white, as the sealer turned it a bit yellow and when dry, stitched the ends to the end stanchions with white cotton.

Navigation

[0] Message Index

[#] Next page